|
福州浩威誠商貿有限公司
| 聯系人：陳素萍
女士 (業務) |
| 電 話：0591-87329862 |
| 手 機：13358203328 |
 |
|
 |
|
| 丸榮主軸拉力計HSK63A/E |
油壓機械式機構，高穩定性
Oil Pressure Mechanical Structure
High Stability
*確認拉力計規格是否與主軸夾爪的規格相對應。
* Check the specification of pull force gauges should
correspond the specification of spindle clamping unit.
*量測環境溫度需控制在室溫25±1℃內。
*Measuring environment’s temperature should be controlled within 25 ± 1℃.
*將拉力計及主軸前端錐度部位擦拭乾淨後，夾持拉力計即可。
* Clean the pull force gauges and front-end taper parts and then
clamp the pull force gauge.
1)HSK63A/E拉力計的調整方式如左圖所示：
Adjustment of HSK63A/E pull force gauge shown on the right.
2)為確保量測數值的正確性，拉力計須在有預拉的情況下使用。
To ensure the accuracy of measurement the pull force;
gauge has to be used in the pre-pull condition.
3)實測拉力：以指針?biāo)竿馊χ當?shù)值X10，即為實測拉力(kg-f)
The finger indicated the value of the outer ring X 10;
the value is pull force measured |
|
|
免責聲明：以上所展示的信息由會員自行提供，內容的真實性、準確性和合法性由發布會員負責，www.qy6.com對此不承擔任何責任。如有侵犯您的權益，請來信通知?jiǎng)h除。